Welding

I think with most project car of the 105-series this spare wheel well and boot floor are in desperate...

This would be the greatest challenge for me. Since this is my first restoration, I didn't know if I would...

When we bought this body, the brackets for fitting the front bumper were missing. I took my time to position...

The right position of the headlight support panels is crucial, because if not 100% correct, nothing will...

On both sides the problem was the same: The lower parts of the inner wheelarches were gone.

Since the floor panels had been replaced, the jacking points were missing. Fortunately I already had...

AS this is always a weak point for these cars, I had to replace it. Unfortunately the quality of the...

Both sides suffered the same rust problems at the mounting points for the rear axle limit straps. ...

This part should not have had any work from me, because it was already done by a previous owner, but...

Again an older repair that didn't last.

This panel was initially the first panel I started the restoration with. At that point I decided to replace...

As the new body already had new floor panels in it, the mounting brackets for the seat were missing....